Question about 31913 Progressive Direct Drive Bagged Upright Vacuum
...brush assembly to take the rest of the string out. Any advice is appreciated. Most of these progressive drives have a bottom plate that you can take off, then you can get to the brush roll asm. There ...
...assembly straight up. Seperate the various housing parts until and foam bits until you have the motor free. Remove the brushes from the housing one at a time by unscrewing the retaining screw. In my ...
...found for my vacuum cleaner when the entire brush assembly in $39.99. This is a very tricky way to get unsuspecting people sucked into paying for something they thought was free. Bad business,
...brush won't turn and it won't pick up lint etc. Heard about a reset switch but where is it? The Agitator Overload switch is located on the top of the base assembly. Unplug the vacuum and press the ...
Question about 23612 Progressive PowerMate Bagged Canister Vacuum
...brush assembly. Install new belt over motor drive, then over brush sprocket. Snap brush supports into place on base. Be sure brush supports are not upside down. Line up front of cover and base. Rest ...
...brush assembly, and pull off the bearing blocks. Clean the pin ends on the brush and the interiors of the bearing blocks with Q-tips, then lightly oil (3-in-one or similar) the bearing blocks and pin ...
Question about 31913 Progressive Direct Drive Bagged Upright Vacuum
...assembly. You can get a replacement belt at Sears or nearly any vacuum shop. While replacing the belt, it would be a good idea to take scissors or a knife (careful!) and remove the hair & other ...
Question about Progressive Canister Vac Cleaner Wand Set 69826
...brush assembly, remove them and you will see the brush and belt, remove each end of the brush assembly they should lift up and out of the housing,and either replace or reailine the belt on the motor ...
Question about 79012 / 79014 / 79019 Gas Kitchen Range
usually means taking the affected parts apart (or removing them) so you can clean them using a toothbrush or similar small brush, and then drying them before re-assembling or re-installing them.
Question about 79012 / 79014 / 79019 Gas Kitchen Range
...the swivel. Tilt the cover forward until it snaps free. Carefully, use your screwdriver to pop the brush supports free on both sides to remove the brush. Slide off the old belt. (If needed, slide
Usually answered in minutes!
234 Questions
128 Questions
108 Questions
103 Questions
106 Questions
