Questions & Answers for: Cadillac brush assembly

...assembly. the pins on that are rusted. they are thick (maybe 20 gauge stiff wires? - the thing looks like a giant video game controller with a screw on it) you may be able use a wire brush f that is ...

...the tube which crosses from thermostat housing to manifold. Tube had rust in o-ring areas. Wire brushed tube then placed a thin bead of silicone on tube areas where o-rings are placed. Installed

How should i wash off my northstar engine? u can wash it off just be carful around the air intake and dont try to get water in the alternator. Hi, whilst people can and do use high power washing wands

...wound field it is possible that the last time the window moved under power the motor stopped with a brush either stuck or in contact with a "dead spot" on the commutator. Assuming the latter and with ...

...try removing the fan assembly and carefully dismantling the motor. Once apart check for worn out brushes and if they are OK, then soak the bearings in engine oil and reassemble. The bearings are ...

assembly in the housing. take motor apart and clean check brushes in brush holder, then sand the armature where the brushes ride. Stretch spring on brushes , the put the motor back together. works 95%

...is the started on it? Yes - your problem is in your starter - specifically the armature and / or brushes. The starter is located on the passenger side of the vehicle, mounted to the front of the ...

...and replace just the drive unit, It's a little involved with putting back together due to the brushes having to be pulled back during assembly.good ...

replace alternator bearings If the bearings are bad then the brushes and other parts will be worn as well. It is better to replace the entire alternator. Unless you have the knowledge to rebuild it. ...

...like battery,but I'm not completely sure--possibly a ground? I've cleaned the terminals with wire brush, and the connectors. I've also cleaned and shined where the negative cable grounds to the ...