Question about 13624 24V Cordless Hammer Drills
...assembly with the spring and brush in one unit. If your springs are bad you can order a set of brushes. The part number is 2607034901 and they run around $6.50. If your springs are melted looking ...
classixx6 will not spin I give you several alternatives, sort out thru the easiest: Note your brand and model. Check on YouTube for change of motor brushes. Then disconnect your motor and check your ...
avantixx 7 doesnt spin avantixx7 doesnt spin I give you several alternatives, sort out thru the easiest: Note your brand and model. Check on YouTube for change of motor brushes. Then disconnect your ...
Question about Nexxt Premium WFMC6400UC Front Load Washer
My washer is alarming "suds or blocked pump"? What can I do? My washer is alarming "suds or blocked pump"? What can I do? Plug off the power cord from the wall mains. I give you several ...
Question about Nexxt Premium WFMC6400UC Front Load Washer
have a bosch front end load washer series 100 nexxt wont aggatate or spin pump is clear and working drive belt good condition, check voltage to motor when controll clicks on 120 then off it is only on
Drum does not turn Plug off the power cord from the wall mains. I give you several alternatives, sort out thru the easiest: Note your brand and model. Check on YouTube for change of motor brushes. ...
Question about Classixx WFL 2066 Front Load Washer
bosch FD8805 washing machine rinse light was on but nothing working replaced brushes on motor were well worn down but still no response machine dead apart from flashing rinse light dn Plug off the ...
Question about Nexxt 700 Series WFMC6401UC Front Load Washer
classixx 5 bosch washing machine stalls/judders at start of cycle first noticed after a cycle left the clothes unspun.Tried selecting spin but juddered/stalled/ hiccoughed it's way through and
will not spin tech sheet Plug off the power cord from the wall mains. I give you several alternatives, sort out thru the easiest: Note your brand and model. Check on YouTube for change of motor ...
...cleaning the cover assembly with a small brush (tooth brush works well), but the mechanism may be worn or broken and need replacement. This should be replaced as an assembly, not just the cover
Usually answered in minutes!
29 Questions
20 Questions
12 Questions