Questions & Answers for: broken side lock Sewing Machines

...side of the material. Also the thread seems to strip thin when this happens. You probably are in need of a new bobbin case they are plastic and oif you have broken a needle lately it may have gouged ...

...side. Any ideas? Sounds like the needle bar alignment is broken. When you turn on the machine, does the needle move from left to right and then goes to center? This is called calibrating to center. I ...

...broken I have this problem when the thread isn't locked into position under the clear plastic guide on top of the machine. You have to hear it click 2 times on the right hand side. You have to pull ...

...trying to thread left lower looper but the lever will not move to the left side. if a part is worn or damaged or broken it's not going to move it need to be checked at a sewing machine repair ...

...thread lower looper. right side is done but the lever will not move to the left. it's possible that a part in the serger is broken or damaged it need to be serviced by a sewing machine repair ...

broken needle in my baby lock serger pro line model BL450 I use a small screw driver to undo the screw, insert the needle all the way into the needle holder--flat side to the back of the machine, then

...side of the machineyou also mentioned that you broke a needle, when a needle is broken some times it can cause the machine to go out of time, which means it has to be taken to a sewing machine repair ...

...handwhell with the allan key but it wont go any tighter I push the hand wheel in but as soon as I prepare to sew it pops out again there could be a part broken in side , the machine needs to be ...

...side of the lock.(sometimes front) e. Turn hand wheel by hand. Did the needle rise and fall? 2. The drive belt isn't moving the shaft. a. Remove the top of the sewing machine. b. You will most likely ...

broken drive belt or internal drive gear failure can prevent the needle from moving. Engage the hand wheel clutch if you have it disengaged for bobbin winding. If the needle won't move with the clutch