Questions & Answers for: Ford broken side lock

side door lock switch. This is a common problem with this model. If you access the wires in the boot between the door you will find a broken wire about an inch from the connector. Hope this helps!! it

broken into with a screw driver hammered into the drivers side lock which knocked the lock completely out of its place allowing the metal bar that lifts the lock inside the door to be reached from the

...is off The switch is finding its ground thru the interior light switch. Your problem is most likely a broken wire in side the rubber boot that goes from the door to the body near the door

broken off (the bottom one when looking towards the ground) the passenger side door. It locks and unlocks, but makes a "machine gun sound when you lock it. no, that is most likely the lock actuator is

...side m,ay be broken. the lock actualator need replaced it inside the door. go to dealer and ask for one then you will see what one looks like, kinda tricky to replace bit will take a couple hours if ...

...broken side door lock 20004 Econoline e250 I have these new vans that I have been installing master lock locks on the doors so they can not be broken into easyly. On this one van I drilled threw the ...

PRESSED, THE ******* SOUNDS ALL OTHER DOORS LOCK OK EXCEPT THE SIDE DOOR take the lock out and have a good look it could have a broken lever inside the lock ,the electrics are all built into the lock

will lock the doors but will not unlock them. The passenger side works so I know the lock is working and I changed the switch and I still have the same issue. Broken wire at door jam where door pivots

...side door lock? Not sure if lock has solenoid or electric motor, but either way, can you hear clicks or any prominent sounds from the door whilst trying to unlock it? you may need to put your ear on ...

...itself but only one wheel is pulling the tractor at this time. Determine which wheel is pulling and which one is not with diff lock on. The one not pulling is the broken side. Disassemble and