Question about WBSR3140DW Top Load Washer
try to remove the dial and insert a broken toothpick in dial stem hole. Replace dial -- object is to get pressure on dial stem to turn the switch knob. You will need to purchase a new dial, obviously
Question about LTE6234D Top Load Stacked Washer/Dryer
...broken off? I believe the selector knob on a Whirpool just has to be turned counter-clockwise with the selector pushed in. It will spin off the shaft and then the outer indicator dial will pull off. ...
Question about LTE6234D Top Load Stacked Washer/Dryer
...broken washer selection dial today, when I went to pull the washing selection dial to turn on the washer, the knob came off in my hand. Looks like I broke a number of little white plastic spokes that ...
Question about GHW9400 Front Load Washer
...dial is broken. When I dial any mode on the right side of the dial, it select a mode on the left side of the dial. If I dial any mode on the left side of the dial, it selects it correctly. Can anyone ...
...dial indicator being broken To replace that you yank out the retaining rod in the rear to release the knob then you can replace the skirt easily Their are four videos and a tech service manual here: ...
...broken motor coupler Set the timer dial in the regular wash cycle. If the washer fills to the selected level and starts agitating properly, then the problem is not a broken motor coupler However If ...
Question about FEX831CS Top Load Stacked Washer/Dryer
...dial or the agitator solenoid. Call in a professional for this. If the washer doesn't budge, then verify that the drive belt(s) is attached and not broken by removing the back panel. If the belt ...
...dial or the agitator solenoid. Call in a professional for this. If the washer doesn't budge, then verify that the drive belt(s) is attached and not broken by removing the back panel. If the belt ...
Question about Profile WPRE6100G Top Load Washer
...dial was broken. The washer is 7 years old, and is usually used on smaller load settings, cold wash, delicate setting, and only about 2-3 times a month. The load size seems to be sstuck on a small to ...
Question about Profile WPRE6100G Top Load Washer
dial in the couter clockwise direct by 45 degrees or so and then resetting the cycle. Thank you. If your washer fills with water but doesn't agitate, the problem is likely to be a faulty lid switch, a
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions