Questions & Answers for: Canon broken ceramic

Canon i9900, orange light blinks 5 times, won't print. I Cleaned the print head with denatured alcohol and it still wouldn't print. As soon as the print head gets all the way over to the right, the ...

...move. i had to change the whole section of print-head just because the flexi-cable was broken when i attempt to open the ceramic part... after you clean them, do the test with maintenance

fixing drive circuit failure cannon iR2016J E808 Hi try to reconect the fixing wire plugs, in worst scenario, the fixing ceramics is damadged. call service or replace fix.film unit.

Canon Image Class D860 - Error message E003. How do we correct? Under service mode ( MENU and # ) find CLEAR, and select ERR ( if you cant find err, select ALL ), and OK. Restart machine. If that does

the ir 2200 is not warming up i change the film sleeve but is no not Hi, do you get error code like E000 or E001? How do You think that copier doesnt warm up? Did You try to replace fixing ceramic ...

canon ir2870 error code e000002 Hello, these means that in fixing assy is low temperature. It can be that you only need to clear the error trough service mode, or you need to change thermistor. To ...

broken down. It uses a toner that could also be used in 3025/3525/3725. It is an important piece of equipment to me as the toner can be applied to ceramics and fired to 1280 degrees Celsius - it seems

what is drive circuit of canon ir2016 how to replace drive circuit Hi try to reconect the fixing wire plugs, in worst scenario, the fixing ceramics is damadged. call service or replace fix.film unit

...ceramic heater inside the fuser is broken. Sadly - this cannot be replaced by itself. Not easily anyways. The whole fuser needs to be changed. This is a 220V model that you are referring to so I ...

e000000-0000 what is the problem plz help me i dont know where is the problem quickly reply The temperature of the fixing assembly is abnormally high. Check the Thermistor of the Fixing Unit. Check ...