Questions & Answers for: Hotpoint broken carbon brush

Question about Aquarius WD640 Front Load Washer/Dryer

1 Answer

...motor or belt problems. Can you hear the motor spinning when it should be? ie on spin cycle. If not suspect carbon brushes in motor, or even a broken/burned out wire to motor. Replace belt if ...

Ad

Question about WMA46 Front Load Washer

1 Answer

...broken. (price for belt is less than 20 pounds.) 2. The brushes in the motor have worn down too much to make the drum turn. Look underneath the washing machine to see if black power (Carbon) is ...

Ad

Question about Ultima WF860 Front Load Washer

1 Answer

...broken. .Check the motor hasn't jammed up somehow, or that the small tacho coil on the end of the motor hasn't dropped off (tip the machine back and it's in between the brushes - it should be held in ...

Question about Ultima WF860 Front Load Washer

1 Answer

...E30 indicates a motor fault. Unplug the appliance from the wall socket, remove the lid and remove the carbon brushes from the motor. You'll probably find them worn out or broken. Good Luck!! ...

Question about WMA76 Front Load Washer

1 Answer

...carbon type brushes fitted I would not expect the brushes to be the cause of the problem in your case. More likely to be a control board problem, or possibly the motor itself. Check for loose or ...

Question about Ultima WF860 Front Load Washer

2 Answers

broken wires from the motor plug to the main control board. Check the main control board for signs of damage or burning. Check that all plugs are firmly seated on the control board and into the motor.

Question about Ultima WF860 Front Load Washer

1 Answer

Washing machine drum does not go round, water goes in and takes wahing powder but then nothing happens?? Carbon brushes in the motor worn away, if not poss broken cable in motor block or motor faulty.

Question about Ultima WD72 Front Load Washer/Dryer

1 Answer

...and take the top off. Either side of the motor you'll find a carbon brush holder. Disconnect the wire to the carbon brush and take the holder out. If worn or broken, replace with new

...were still wet. I have checked the obvious, the carbon brushes are ok; the belt is ok; it fills with water ok and drains ok. The belt has slipped off or broken. Take the front off and put it back

...broken fuse replaced ? maesured ? heating element measure are there burning control lights ? , or no function at all program clock defect ? , its in safe mode because of overheat protection ? , make ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machine Experts

vince

Level 3 Expert

2530 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Paul Carew

Level 3 Expert

3808 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...