...carbon sticks at one end of the rotator (spiny bit in middle of motor) there will be two (opposite each other) connecting to the commutator (round copper looking ring with slits in it). The brushes ...
...the gooves of 2 pieces of metal. This is what makes the tool turn. This plastic piece in mine was broken to pieces So that is the problem. I have not found that little tiny piece of plastic and I ...
Model 395T6. was intermittent, changed brushes, doesn't run, put old brushes back, still dont run. checked with voltmeter, getting power to the connections. did you check the switch?or broken wire.
Question about 4000230 High Performance Rotary Tool Kit 4000230
...brush is a little carbon square attached to a wire with a spring on it. Real simple. Buy a pair and get it fixed up. My favorite tool. No they don't have them on the shelf in Walmart. If ...
...carbon brush, check the length of the brush and replace if worn down, replace the brush cap and run the tool without load for five minutes to bed the new brushes in. (if the brushes are ok make sure ...
Question about Variable - Speed Multipro Rotary Tool 395
...carbon brush with a slight arc cut in it if you have any brush left. Hopefully, you have little or no brush and a spring. Then it's easy to replace (my brushes were OK and just ...
...HAPPENS Sometimes the battery fails in these units. Take it apart you cannot hurt it. Look for broken wires, worn out brushes, etc. the switches on these fail alot it may need cleaning or ...
Question about Variable - Speed Multipro Rotary Tool 395
...broken brush this is a small carbon object inside that makes motor run, dremel does sell replacement brushes for most of what they mfg. look where ever real dremel bits and tools are sold ck package ...
Question about Variable - Speed Multipro Rotary Tool 395
My Dremel just stopped, didn't get hot, but sometimes it makes a squelling sound, brushes are fine, what do i do check for a broken / damaged drive cable
Question about Variable - Speed Multipro Rotary Tool 395
I was using a circular bit on my dremel to cut into a copper sheet. All was dandy until it suddenly stopped cutting when I touch the blade to the copper. Does anyone know what the issue could be? I ...
Usually answered in minutes!
163 Questions
35 Questions
27 Questions
32 Questions