...bridging. Please note, that when you bridge that your speaker load DOUBLES to EACH channel. In other words, what your amp saw as a 4 ohm speaker going to one channel alone, it now sees as a 2 ohm ...
...4 channel amp (or get a 2 ch amp and bridge it) and connect the sub. Bridging = connect + of sub to + of one channel, and connect - of sub to - of *other* channel. Check amp manual for instructions. ...
Question about PLA4340 Car Audio Amplifier
4 to the other one. But the amp is only rated for 75 watts RMS per channel and Pyle products are sometimes rated higher than their real capabilities. So, even bridged and with the rated output, you'll
...bridging it? How can i bridge the power to this sub? It sounds like the problem is with the amp. try using the other sub in bridged mode and see if it still turns it off. If it still turns off then ...
...4 ohms connect it to a 2CHANNEL AMP and BRIDGE IT (connect + of the sub to 1st channels positive of the amp then connect - of the sub to 2nd channels negative of the amp) . The power will be doubled ...
Question about (SLH-T7512X2-A) Car Speaker
...4 channel 700 watt ken wood, 2 channel 800 watt Sony, 4 channel 740 watt Jensen ,and a 2 channel Rockford fosgate. Which is best way to hook them up so I'm not ki Pace posted on Saturday, March 05, ...
Question about (SLH-T7512X2-A) Car Speaker
...you can't bridge that amp onto two 4 ohm subs. To get the most power out of your subs is easy. Run one channel to one sub and the other channel to the other sub. 165 watts RMS is plenty for most
Question about (SLH-T7512X2-A) Car Speaker
4 channel amp 36401 be bridged on bchannel. and what would the ems be? You can bridge the speaker outputs; positive from channel two(2) , and negative from channel one (1) : Positive from channel four
Question about (SLH-T7512X2-A) Car Speaker
4 four channel amp when it is 2 ohm stable and ur subs are wired up as series/ parallel and there 2 ohm dual voice coil speakers If you wire 2 ohm dvc speaker parallel that would give you a 1 ohm load
Question about (SLH-T7512X2-A) Car Speaker
...one channel The mtx thunder is a 4 channel amp. 4 channels can't be bridged to 1 speaker. You can only use one side of that amp to bridge your speaker. Unfortunately your now only using half your
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions