...ohms and run fine stereo, but if you bridge them it will show a 2 ohm load bridged to the amp which means 1 ohm per side. The amp is not stable at the impedance. Get 2 ohm/8 ohm subs or "Dual 4 ohm ...
...to run at). Have you bridged your amp? Usually when you bridge your amp it lowers the ohms by half. You may have damaged something, especially if you bridged your amp and didn't bridge it
...ohms then bridge each amp and run one speaker per amp on a bridged channel. One behringer amp bridged to one 4 ohm 2000 watt program speaker. just be careful not to over power the speaker because you ...
Question about EUROPOWER EP2500 Amplifier
Power Acoustik LT 980-2 clipping while bridged pushing 1ohm load clipping while bridged pushing 1ohm load, power acoustik LT980-2 Hello, your problem is that your amp is rated at 4 ohms bridged mono ...
Question about Xplod 1200W Class AB Bridgeable 2-Ch. Amplifier w/Variable Low-Pass Crossover
...ohms speaker load on bridge mode. some amps are never designed for bridge mode. so if u bridge these amps u will get less output. u have to be very careful when u make the connections. plus when u ...
I need to know what the wattage the alpine mrv-f407 puts out when its bridged or only running 2 channels? RMS Continuous Power (at 12.0V) Per channel into 4 ohms...............40W, 0.08% THD Per ...
Question about PRS-X720 Car Audio Amplifier
BRIDGE IS BURN OR MY 2 CHANNEL? PLEASE HELP From the specs this amp can only handle 4ohms when bridged but can handle 2ohms when it's not bridged Specifications Continuous Power (20Hz-20kHz, 0.04% THD
Question about PRS-X720 Car Audio Amplifier
...ohms. So you can't bridge that amp onto two 4 ohm subs. To get the most power out of your subs is easy. Run one channel to one sub and the other channel to the other sub. 165 watts RMS is plenty for ...
Question about PRS-X720 Car Audio Amplifier
So how do wire this set set up to a bridged amp any help would be appreciated assuming that is a dvc dual 4 ohm speaker, and you have a 2 ohm bridged amp, you run a positive from each side of the ...
...ohms. The Bridge rating is 1500 watts RMS into 4 ohms (minimum load). Bridge mode operation is accomplished by placing the MODE switch in the BRIDGE position, using only the BRIDGE Speakon connector ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions