break lights. After research online, I found that the multi function switch was the problem. Replaced the part and my left and right brakes are working once again. You do not have to take the steering
1996 jimmy no break lights ? what do i do to fix this problem thanks try replacin the brake switch behind the brake pedal that should solve this hope this helps
...with my car. the door drops down when you open it, and because its off balance, it bends and breaks the little stick that pokes out very simple to replace if thats the case. a few screws to ...
160;board that's inside the wind-shield wiper motor. Apparently the solder cracks and breaks the connection. If If so,,,,, then you should be able to re-solder the board.
...type take a break and try installing it again a little later.The ignition switch should be held in by a bolt. Once the bolt is removed the ingition switch slides out and the new one can be
...retest switch new doesnt mean not defective if no power check connections and wiring for damage or ...
break light switch? Is it something I can fix my self?? Hey the switch could be a problem but before you do that check the ground on the harness going to the brake lights. It's most likely going to be
break lights? Check the brake light switch should be a orange wire with 12v then a white wire with 12v when the pedal is pressed.If htat cks good then ck the hazard switch by moving it up and down and
...break switch. The break switch is located by your break pedal itself. If you locate and replace the switch it should solve your problem. I hope this helps you out. also when replacing the break light ...
...switch in a 1987 gmc s15 pickup Most ignition switches are fastened with Break bolts , which means they are tightened until the head breaks off .,This is to stop theft. You have to drill out the old ...
Usually answered in minutes!
1,363 Questions
1,123 Questions
1,127 Questions
1,104 Questions
838 Questions