break lights indication I have a Mazda MPV 2003 and always has the parking breaking indication, I release it, but the indication does´t turn off. I checked the Switch and it is working properly. check
...correctly TRY PUSHING DOWN ON THE HAND BREAK AND SEE IF THE LITE GOES OUT . THE HAND BREAK HAS A SWITCH THAT TURNS THE KITE ON WHEN YOU APPLY THE BREAK FIND THE SWITCH AND SEE IF IT IS ...
where is located Brake Switch on mazda 6i v6 2005 problem:they have the code P0703 The break switch is located on the metal bar of the break pedal.. Have a great day !
all my rear break lights are out.where do I find the fuse for my break lights? check first brake light switch
...Break Light Switch The brake light switch is located behind the brake pedal. To replace the brake light switch, first disconnect wire couplink ,next unscrew the switch from behind the bracket. You ...
...you have a bad break switch. It is usually located on a bracket right behind the brake pedal bar. A new switch is generally $30 to $45, and only takes a couple of minutes to change. I hope this
...break switch. It is located under the dash and the break pedal actually hits it. It look chrome and it is a round cylinder. It has a button on it. When you press the pedal down, the button releases, ...
...break lights stay on I had this same problem. I turned off my car and the brake lights stayed on. I looked under the dash and found that the brake pedal, when not pressed, barely touched the brake ...
Question about 1996 Protege
i have a 1976 chrysler new yorker and i do not have any break lights . all fusses are good I can not get the break lights to work at all check brake light switch for sludge formation between contacts
Question about 2002 Tribute
...break lights either??! The brake light switch at the brake pedal controls the brake lights and the gearshift release solenoid. It should have no effect on the signal lights. You may have 2 problems. ...
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions