Questions & Answers for: t s brass

primer button bowl brass bolt and plastic. the bowl under primer button,took apart to clean not working well,already changed plug and air filter was told to check pin hole in brass bolt, was dirty but

Hobart A200 Worm Gear Shredding Brass Gear I have an older A200 that walked it's way off of the table one day and fell on it's face. The spring behind the worm gear broke and fell into the brass/worm ...

brass part in wand handle because the brass fitting brass part in wand handle because thebrass fitting is broken. Where can I get a new fitting. Water sprays out of handle of wand. Small brass fitting

...which controlled separately a bathroomm fan and a light which to use One side of the switch has Brass screws, and the other has nickle screws. there is usually a small brass bridge between the ...

...Green screw is for bare ground wire. 1) One side will have dark screws and the other side will have brass screws. The dark screws will be connected together with a brass plate. The brass screws will ...

...build pressure Where are the valves located? There is one valve under each of the six large, brass bolt heads on the end of the pump.  As water tends to make brass peices stick together, ...

Need to remove broken 3 / 8 brass elbow prt #112.I am using a homemade extractor a right or left handed threads or anything it. Any tips would be greatly appreciated thank you. 99% of threads for ...

my church is looking for brass band instruments funding,but we don't seem to get one .try lots of fund raising activities
using church hall and car park

church fete
baby sitting