Questions & Answers for: brakes push back

Question about 2000 MX-5 Miata

1 Answer

...Brakes How do I push the brake cylinder back on rear disk brakes for a 2000 Mazda MX5 Miata? you cannot push back cylinder you have to wind it back using a wind back tool or if your strong enough you ...

Ad

...brakes changed. My rotors are good. When i push on the brake pedal it make a little scratching sound like and it will go all the way down and then push back out. Nobody knows what is going on. you ...

Ad

brakes will have to be bleed after replacing the calipers, (If you replace one side recommend replacing the other side) Are you talking about brake caliper piston? A large C-clamp is typically used to

Question about 1997 Grand Cherokee

1 Answer

...brakes. TRY EITHER OR #10 OR #11 BELOW: After the new Caliper is reattached to hose and has been bled: 10. Again push on the brake petal to fully extend the caliper piston fully (rubber seal/boot ...

Question about 1997 Grand Cherokee

2 Answers

brakes when i push on the petal You need to bleed the brakes and get all of the air out of the system. It take a few full brake applications for the new brakes to seat in properly, and check the brake

Question about 1997 Grand Cherokee

1 Answer

...push back the piston of a rear brake caliper on a 2002 ford galaxy? Please help. remove caliper from rotor,remove lid from brake booster.use a c clamp to push it back in.put an old brake shoe between ...

Question about 1997 Grand Cherokee

2 Answers

...brakes on a 2004 hyundai elantra? Can i just use a c clamp to push the brake fluide back into the resivor? Yes you can just a C clamp to push back the piston on the front calipers, don't forget to ...

Question about 1999 Taurus

2 Answers

...push as well if not use a c clamp the same way BUT DO NOT USE THIS PROCEDURE FOR THE REAR BRAKES IT IS NOT THE SAME ONLY FRONT BRAKES for the rear if you have calipers instead of drum brakes you have ...

changing brake pads on Laguna 1800 16 v cannot get brake cylinder pushed back in how can I do this brake cylinder will not push back in to replace new pads is it front or rear brakes

Question about 1999 Maxima

1 Answer

...brakes now when i push them its like i have to push all the way to floor how do i build my brakes back up If you have drum brakes on the rear you will have to manually adjust them up till they only ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...