Questions & Answers for: Shoprider brake scooter

...scooter beeps when i push lever to go forward i get a click near the motor .motor does not turn hi, sounds liek a bad connection to the brake, Check the connections from the brake (on the side of the ...

...scooter? If you cant push it the the brake solenoid might be the fault. I have had a few over the years that have done this. The resistance through the coil should be approx 50 ohm's. Otherwise the ...

...scooter finally moves it hesitates for a short distance, then drives ok. Brake assembly seems to be ok. Could be a throttle pot problem and /or a speed control pot problem one or both could be dirty ...

...scooter beeps as soon as I turn on the power. It shows a full charge, but there is no response when I push the lever. The brake is released. The horn works. Boy I hate working on scooters too many ...

brake is of the scooter will beep,letting you know the brake needs to be engaged . Hope I was of some help ,Good luck Check if your alarm is on, try and disarm it and make sure your battery is charged

...brake released overnight and the scooter is running fine now I wouldn't do anything now but keep an eye on the motor and battery drain If the scooter won't push in freewheel again then the ...

brake must be faulty, so please clarify does the scooter work okay when you push the forward or reserve lever ? Remember the brake release when you push the throttle lever by applying 24v to the brake

...Scooter still wont run and when I am sitting on it it wont come on orit does then shuts off. I suspect the brake cable is not attached properly. Hi, it's only a loose connection or bad connection, ...

emergency brake faulty as it does not stop the scooter when applied hi, what scooter are you refering to please ? Regards Rob www.gewizrepairs.co.uk

...brake lever is on so the scooter is hard to move. If it is easy then it is not on and won't drive. Make sure there are not any cables that are disconnected to the motor and brake. Scooter Doctor ...