Questions & Answers for: brake issues

have viper 791XV install in my car, recently somethings wrong with the system. I tried to press the brake without the key turned in/on and the engine still running which supposed to stop right? Notice

...at high speed After changing the wheel bearing on the front driver side of my uplander, and put new brake pads, it is now shaking when braking at a speed higher than 60mph. braking at low speed is ...

...brake system needs inspection. To troubleshoot these issues, I suggest you to refer the help link provided below. There are direct links with accurate solution, for these specific issues. Click the ...

...when brakes are applied? possible causes? brakes began having issues recently, but haven't addressed the issue yet Brake pad wear warning sensor scrapes only when brakes are not applied. Replace ...

...brake issues), and could be one of three things: Failed or failing ABS unit (most likely); Brake fluid leak (highly likely); Bad master cylinder failure (somewhat likely). IMPORTANT: BRAKE ISSUES ARE ...

...brake noise issues. Just as a side note, residual dirt and grease from the installation itself can cause noisy brakes for a few days/weeks after first install until it is worn off and the pads break ...

...brake and reverse light circuits even when the car is turned off. Finally, there may be an issue with the car's battery or charging system. If the battery is not providing enough power to the car's ...

...brake lights. As for the discrepancy between the 3-prong relay and the 5-prong relay, it is possible that there have been changes or updates made to the electrical system of the vehicle over time, ...

...brake issues on your 1970 Chevelle, it is important to properly diagnose the issue before attempting any repairs. Some common causes of brake issues include a malfunctioning master cylinder, damaged ...