...to turn off the car and repeat the process over. check to make sure you have brake lights when trying to shift if not check the brake lamp switch if it is ok you might need a shift interlock ...
minutes it will finally release and got into gear. These are usually interlocked with the brake. I'm not sure about where the switch would be for that but the brake must be pressed to put it into gear
...it's most likely a bad brake lamp switch which is located at the top of the arm that holds the brake pedal on, if you look up find the switch and unplug the harness, if it goes out there's your ...
...the light is probably bad but what id do first is try to adjust the switch which is located under the e-brake.look at the back side of the e-brake and you should be able to see the back of the
Question about 2002 Explorer Sport Trac
...brake switch on pedal and still no lites all i have is tail lights Power for the brake lights go thru the turn signal switch before getting to the light bulbs. Do you have power in and out of the ...
Question about 2005 Explorer Sport Trac
...brake switch senor or the interlock selenoid. Break lights do work when pressed. Some times have to turn the vehicle off with the ignition on and move the shifter into in order to get it in gear It ...
...no brake lights but running lights and turn signals working There's a switch on the brake pedal arm, the switch controls the brake lights. It may need an adjustment or replacement.
Hope this
Question about 2002 Explorer Sport Trac
...switch, causing the red brake warning indicator to illuminate. Loss of brake fluid will cause this system to activate. The brake master cylinder is a dual-piston type. The brake master cylinder is ...
Question about 2002 Explorer Sport Trac
...do with your brake light good luck Most brake light circuits are wired through the signal light switch. Are the signal lights yellow or red? Have you checked the brake light switch at the brake
Question about 2002 Explorer Sport Trac
brake switch, look near the top of the brake pedal arm you will see a switch remove it, clean it, replace it. If issues are still there check your wiring for good connections, recheck fuses in car and
Usually answered in minutes!
305 Questions
209 Questions
79 Questions
7 Questions
2 Questions