...brake pressure. This will also make you think the lines are not bled properly because of the increased pedal pressure you are putting on the wet/lubricated front pads. If so, replace the pads. Don't ...
...to sit for a few hours, respray every 25-30 minutes. Then when there done spray well with a brake cleaner to remove rust, then allow to dry spray with a wd-40 then a white lithium grease, should do ...
...brake cleaner and rags will be your friend. Your car will run just as smooth as it did when it was new after your all done. buy a haynes and chiltons book for you vehicle, they will be your ticket to ...
...brake cleaner into the throttly body when it doesn't start. If it now starts then you will know its a fuel issue. If it still does not start then you have an ignition issue. The crank sensor, the ...
...brake job. you also dont need power steering flush. If you have work done on the rack and pinion or the pump replaced they will add fluid as needed and bleed air from the system but you shouldnt need ...
...cleaner to a tank of gas twice, no improvements. It gets worse as the engine warms (after 5 mins) Thanks! Hi, Improve the Fixya.com experience for everyone by voting! The steps I'm going to ...
Question about 2002 VUE
...brake cleaner then let dry for 15 minutes and re-install.You will need to reset the computer afterwards.This is for the 3.0 engine the 2.2 does'nt have a mass air flow sensor it has a map sensor ...
cleaner. Didn't remove from vechicle. Did the learn procedure for idle. Seems to run ok - but noticed a slight surge in rpm while driving, shifting a bit higher than normal. Also, shifted car into
Usually answered in minutes!
1,183 Questions
693 Questions
496 Questions
452 Questions
367 Questions