engine start the engine takes a long time to start Check to see if your crank sensor has a bunch of oil on it. If it does, I use brake cleaner and clean it all off.
...is not releasing fully try cleaning caliper wiyh brake cleaner and lube the caliper slides with brake caliper grease front caliper isnt releasing. you can try to clean it but best to replace
brake it takes off increasing speed until I hit the brakes. Even in Neutral and Park the engine revs at over 2000 RPM. What would cause this to happen? most likely it is an intake leak somewhere after
...drums off and getting all the brake dust out of the brakes with the garden hose and using compressed air to dry them or buy a can or two of brake parts cleaner at you local parts store,hope this ...
...obviously sprung a leak in the radiator.Clean everything off w/Engine Degreaser or brake cleaner. Have someone start engine for a moment and look closely at front of radiator facing engine for the ...
i'm getting black brake dust on my front tires This is a normal thing. As the brakes wear you get dust. get a bottle of wheel cleaner and it will remove the dust Good luck!!
...brake cleaner, a small packet of brake grease, a large 4 inch C clamp, and possibly new rotors if the old ones are bad (abnormal wear or it they are out of spec). Start by jacking up the car one one ...
...brake booster hose and the electrical harness in the holders on the end of the valve cover. Attach the electrical connector(s) to the camshaft position sensor and coolant temperature sensor (if ...
...brake and clutch cleaner then a drop of engine oil and some LM grease ,to remove the brake disk depends if its a front or rear one ,but either way the caliper support is unbolted from the back ,not ...
...by itself, and then I can't brake. What is going on? The engine is taking in air past the MAF, the pipe going from the air cleaner box to throttle body may have a leak in it, replace
Usually answered in minutes!
861 Questions
762 Questions
743 Questions
710 Questions
606 Questions