...brad jammed in the nailer--that's exactly what mine was doing. I had to remove the front plate (there are three torx screws) to see the brad that was stuck. Once I got it out and re-assembled it, it ...
Question about Nailer Kit, Palm Air Driver
...brad nailer won't nail unless I release thenails from supply, remove the front cover, slide up I think it's calleda striker, then replace the cover, re-set the supply and nail. How canI fix this ...
...brad nailer. Today it started discharging the exhaust air slowly after each fire. It's like it "hisses" for 4 or 5 seconds before it's ready to fire again. It used to take just a ...
nail gun fires but no nails are dispensed no nails are ejected make sure nails are loaded properly and there are no jams
Craftsman brad nailer model 68563 wont fire Jam, low pressure
Question about 18 Gauge 1 38" Brad Nailer Kit
...brad nailer that wont fire. The battery is fully charged and works in other tools. The LED light will turn on for about 1 second and then turn off. Any ideas? not completely familiar with that exact ...
Question about 18 Gauge 1 38" Brad Nailer Kit
Brad Nailer won't fire a second brad. Brand new Craftsman compressor and nailer. is the plunger sticking below the housing . if so push it back in with a screw driver
Usually answered in minutes!
317 Questions
162 Questions
122 Questions