Questions & Answers for: Dodge Neon brackets

Question about 2001 Neon

1 Answer

removing a starter i have a 2001 dodge neon i am trying to replace the starter but cant get the lower bolt out due to some kind of bracket do i have to remove this bracket Yes, you'll have to remove ...

Ad

Window on 1999 Dodge Neon has broken brackets on track I want to replace the broken brackets, but it is difficult to see how mechanisms work. take door panel off, inside door is window regulator. ...

Ad

Question about 2001 Neon

1 Answer

Scanner reads code (060) Wich said that engine ECM is faulty, so I want to locate engine ECM and get serial number or part numbers inorder to get a reaplacement...Where is ECM located? Location of ...

how do I change the rear shock on my 1999 Dodge Neon? Raise and safely support the vehicle. Remove the wheel and tire assembly. Unfasten the retainer(s), then remove the hydraulic flex hose bracket ...

Question about 2000 Neon

2 Answers

What does an Engine Mount Bracket look like on a Dodge Neon 2000? it has more than one motor mount there is one in front of vehicle lower part by radiator its a bracket that holds the motor mount ...

i bought a radio from a 02 neon w/wire bracket but i have a 2000 neon and 4 of the wires dont match up and if i do splise in the 02 bracket are they compatable. thank you I would say you need wiring ...

I have a 2004 or 2003 Dodge neon and my brake lights are on even after I turn off the car and the lights I have to have the battery disconnected to shut them off what do I do sounds like you have a ...

Question about 2003 Neon

1 Answer

ghostly brake pedal my brake lights wont come off unless i disconnect the battery sounds like you have a bad brake pedal switch or it has come loose from the bracket.It is located under the drivers ...

changed caliper on passenger side 95 dodge neon bleed caliper locks up wont release brake pads check the brake bracket ,if you use wrong bracket and check the brake caliper casing .

Question about 2002 Neon

1 Answer

...linkage how do I adjust a shifter linkage ? 2002 neon is cable shift and usually the cable fits in brackets. there is alignment pin in shifter base. put a pin in to hold it in neutral position until ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2002 Dodge Neon
2002 Dodge Neon

861 Questions

2004 Dodge Neon
2004 Dodge Neon

762 Questions

2003 Dodge Neon
2003 Dodge Neon

743 Questions

2005 Dodge Neon
2005 Dodge Neon

710 Questions

2000 Dodge Neon
2000 Dodge Neon

606 Questions

Manuals & User Guides

Loading...