Question about Featherweight II 117
...bottom stitch is okay but top stitch puckers. I have tried adjusting the tension on top but stitch in still the same. Peggy pucker is caused by too loose or, to tight adjustment of: the thread ...
bottom tension to tight stiched seam is not balanced the bottom tension is to tight. How to adjust...If I tighten the top tension, it puckers the vinyl. I found that sewing this type of fabric you ...
...check bottom tension...but first make sure your threading machine correctly either bottom first or top tension....top tension should be set to 4-5 bottom should feel when pulling about the same ...
...tension from bottom or upper tension, With presser foot down check to see if you pull thread that you feel tension from pulling bottom thread and that you also feel it from upper free pdf manual here ...
...bottom tension or reduce the top tension .. you will notice a little screw on the bobin case ... that screw adjusts the force on a small flat spring which provides the bottom tension (the thread goes ...
Bottom tension too loose. My machine is approx. 3 yrs. old. I sew with the tension on Auto and have had no problems. all of a sudden the bottom tension is too loose. I cannot seem to get it adjusted ...
...bottom tension problems Lower tension a problem ??? tighten the little screw on the bobbin carrier... a little at a time. are you sure it's the bottom tension? Loose top tension will ...
Question about Touch Sew 7462 Mechanical Sewing Machine
...bottom tension until it moves with tension of four on the upper tension. Put the top tension at four. It should allow the thread to be pulled through the tension mechanism with a slight amount of ...
Question about Touch Sew 7462 Mechanical Sewing Machine
...down. If the bottom thread tension feels loose, similar to top thread presser foot up, then likely the bottom thread has escaped the bobbin case tensioner. Reload bobbin and recheck bobbin
Question about Touch Sew 7462 Mechanical Sewing Machine
...bottom thread (bobbin) tension. Be sure it is top thread. Use a different color top vs bottom color to know for sure. If you find it is bottom thread, likely cause is thread escaped bobbin case ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions