bracket, all belts ( A/C, power steering, and alternator ), thermostat housing and and hoses, fan shroud, then crank pully ( 6 - 10MM bolts around a large 21MM center bolt, dont worry about the center
...bottom of the bracket is held in by a motor mount bolt reinstall this bolt after removing bracket then one or both bolts come from trans to starter be sure to get ground wires back on bolts during ...
Question about 2000 Sportage
...bottom of the blower/evaporator housing. Move the carpeting from the bulkhead to gain access to the hole cover plate. Remove the 4 hole cover plate nuts and the plate. Remove the 2 upper ...
...bottom of bracket remove bracket. remove 3 14mm bolts from starter one is on top and kind hard to get at (3/8 swivel is required) lower starter care full it will fall on you head if you let it remove ...
bracket, all belts ( A/C, power steering, and alternator ), thermostat housing and and hoses, fan shroud, then crank pully ( 6 - 10MM bolts around a large 21MM center bolt, dont worry about the center
...bracket by fixing the mounting bolts in to the bottom. Attach the belt to the alternator and fix it in place with the tension bolt. Place the splash shield back on the vehicle and insert the coolant ...
...bracket by the mounting bolt at the bottom. 13a. Place the belt onto the alternator 13b. Install the tension bolt and snug up belts and tighten bolt to keep belts tight.. 14. Re-install the fan, air ...
...bottom of the pulley/pump. Then there is a bracket at the side that has a long bolt you have to tighten the belt with. Look at the belt first and make sure it is not rotten/cracked. If so, I would ...
Usually answered in minutes!
1,074 Questions
1,058 Questions
918 Questions
753 Questions
343 Questions