Questions & Answers for: Kenmore bottom bracket

...bottom out and lift and the front cover from the housing. (Fig. 27) 2. Remove the two (2) hex-head screws securing the metal control panel cover to the dispenser housing. This will also free the ...

...Light The light won't turn off when you close the door to the refrigerater Hi there check plastic angle bracket on bottom of door is not broken as it pushes the fan/light switch.Hope this ...

...bottom edge of the cover and you will see 2 slots for a flat tip srew driver carefully pry the cover off you will expose the switch bracket and most likely will see the broken pins. just change the ...

4. The bottom support bracket must be removed, and remounted on the opposite side, with the pin sticking up. 5. Reinstall in reverse order using bushing and shims as needed to assure correct alignment

...bracket and misaligned door the bottom door was not closing right and I noticed the bracket holding the screws between the frame and door was bent. I tried to loosen the screws and of course I broke ...

...bracket on the bottom side. LOOK and roughly draw the path of the belt. Feed the new belt around the drum. The last thing is to adjust the tension below. Its spring loaded, so no exact measurements ...

...bottom on each side are a pair of screws that go through the lid and attach to a reinforcing bracket on the inside. Take these screws out, remove the bracket, do the same for the other side. A small ...

bottom. I put the bracket back in the slots but there is nothing there that actuaklly holds it in place so I put a thin metal pc across it and bolted the pc in place. However this nothing to cause the

...it be flpped on its side? or will this do it some damage? Can it be taken apart - the top from the bottom? Thankyou Good Morning; Thanks for your question. The easiest way to move and transport your ...

...there should be three screws on the hinge bracket that connects to the top of the freezer.  take out those screws and remove the bracket.  the door will then lift off the bottom