Questions & Answers for: GE bottom bracket

..., outward , from the bottom of the board . Then remove the 4 screws , holding the switch bracket . The switch bracket slides out , and the 3 screws holding the solenoid and plunger will be visible

...bracket. Tried to push up on phone but it won't budge. Some phones have a little clip on the side of the phone you have to pull out before you can slide the phone up. After pulling the brass clip out ...

...tub to bracket. If one is missing (which it probably is) look around in bottom of washer & locate it. All these bolts have to be very tight & this unit is bad about bolts backing out on their

bottom pin that holds the lower front door to the cabinet. Now what do I do? the pin is stuck and wont come out. I have removed all bolts and screws and my door is off, so of course my food is getting

...will compress and the tub will lower. There is not much of a gap between the shipping bracket and the bottom when the tub is loaded down so if the bottom was bent upward even a little, it could

...the top plastic cover that hides the freezer bracket. Remove the screws that hold it on. pick the door up off the bottom bracket. if it has a water dis unhook hose. do the same to the fridge ...

...bracket on the front and back of the pedestal with screws going into the bottom of the washer or dryer.  Many times it is inset so you do not normally see it.  Remove the screws in the ...

...bracket is bending so much that the motor is rubbing on the bottom frame. You should wear marks there also if I am correct. Here is a link to the new bracket. Here is a video to show you how to ...

ARE 5/16TH SCREWS.MAKE SURE THE HAVE DOOR SHUT OR SOMEONE HOLDING THE DOOR WHEN DOING THIS. AFTER REVING SCREWS AND BRACKET LIFT DOOR UP OFF BOTTOM HINGE AND WATER LINE FROM DOOR WILL COME OUT WITH IT

...on one side. Appeared to not be engaged on bottom. I pulled up on the door to reengage bottom bracket. Now door seems too high to shut. The door may not have been correctly reinstalled on the