Questions & Answers for: bosch lint sensor

Question about Axxis WTA 3510 Electric Dryer

5 Answers

...Bosch dryer and the lint filter warning signal beeps when there is no lint on the filter. It will beep after 5 minutes and you have to open the door and close it to start it again. Please help it is ...

Ad

Question about Nexxt 500 Plus Dryer

3 Answers

...lint filter but nothing helps. My wife has a Bosch Premium dryer that had drying problems. The lint filter would get cleaned but the machine still did not operate correctly, as you explained above. ...

Ad

Question about Axxis WTA 3500 Dryer

2 Answers

lint trap? Our Bosch dryer has the easy one that's located in the door and a second one to the lower left of the front - you have to pull it right out and rinse it out. I had no idea it was even there

Question about Nexxt WTMC 3300 Electric Dryer

1 Answer

bosch dryer lint sensor light comes on; at start up and wont start cycle with the push of the start button. Cleaned entire dryer still have an error code when turned on and dryer still won?t start. Q,

Question about Axxis WTA 3510 Electric Dryer

3 Answers

...Bosch Axxis WTA 3510 electric dryer. The check lint filter light is coming on very often and the clothes aren't drying properly. Lint filter is clear. Checked the exhaust vent outside and the ...

Question about Nexxt WTMC 6300 Electric Dryer

1 Answer

...BOSCH NEXXT 500 ELECTRIC DRYER IS RUNNING ON 20 MIN AIR DRY BUT WITH NO HEAT. SOMETIMES BY SLOWLY MOVING THE DIAL WILL ALLOW THE HEAT TO RUN FOR A FEW MINUTES. THEN LINT SENSOR GOES ON. HAVE CLEANED ...

...Bosch continues to give E01 error with lint filter flashing cleaned lint filter and exhaust and still doesnt work. Try cleaning out the compartment below the lint filter. There's a sensor in there ...

have clean the lint trap my Bosch front load dryer and the Lint light keeps coming on and the dryer won't work what do I do The sensor is most likely dirty, remove it and clean it or better replace it

Bosch electric dryer quit heating. Continuity across reset thermostat button. Installed new heating coil unit. Dryer runs awhile then gives a "check lint filter" message. Lint filter spotless. Sensor ...

Question about Nexxt WTMC 6500 Gas Dryer

1 Answer

...Bosch dryers, these lights will flash to indicate a overheating error. It can be caused by a lint build up, a problem with the temperature limiter sensor or the thermostat. A wiring problem between ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Dryers Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Dryers Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...