Questions & Answers for: Chevrolet Camaro booster

brake booster is not holding brakes when turned on only works when off or unpluged i have a 79 camaro the booster when ever the car is turned off i have brakes when i turn the key on i don't have ...

Ad

Question about 1985 Camaro

1 Answer

brakes soft replaced mstr cyl , brake booster , pads , bled four times, people say it is a vacuum problem how is it a vac problem thanks luman Hi mate, ok here are a few quick tests to perform. to ...

Ad

...a 94 v6 camaro and am missing a vacuum line on the manifold. One side is connected to the brake booster hose. What goes on the other side? evap system to fuel tank Sounds like, there is no power ...

my brake boosters are going bad because when I come to a stop I have to mash really hard on my brakes just to slow down or stop, my pads are fine. are they hard to change? First off there is only one ...

the motor is about impossible to get your hand in between the plenum and intake. REMOVE POWER BRAKE BOOSTER HOSE ON THE INTAKE.BUY A SMALL PIECE OF THE SAME HOSE TO POWER BRAKE BOOSTER.PUT IN ON POWER

...recovers when the brake is pushedlow idle when going slow you might have a vacuum leak in the brake booster disconnect the vacuum booster plug the hose and see how the engine runs and check your ...

i have a 1984 camaro an when i apply presure to brake its real hard to push down You lost the power booster. Look at master cylinder (where you put brake fluid in) and behind it is a large, black, ...

Question about 1986 Camaro

1 Answer

...will find the fuel pump relay located on the firewall of the car. Look to the right of the brake booster. Between the booster and the hood hinge. You should see two relays. The closest to the

Question about 1986 Camaro

1 Answer

On my old brake booster, the little rod from the booster to the master cylinder can easily be be pulled out. On the used booster I bought, the plastic device around the rod follows the rod out. What ...

...STOPPING WHEN I STAND UP ON THEM A hard pedal would make me think there is a problem with the brake booster area. Check and make sure it still has a vacuum connection and that it is not plugged. That ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...