Questions & Answers for: GMC booster

...told it may be the vacuum hose on the master cylinder more than likely it is a vacuum leak in the booster CHECK BRAKE BOOSTER AND BRAKE BOOSTER CHECK VALVE.TO CHECK BRAKE BOOSTER CHECK VALVE.YOU ...

Ad

when i step on the brakes the engine idles fast, I think I need to replace my pb booster, is it a tough job? it should when you push the brake pedal but only for a second or 2. if idles up and stays ...

Ad

Any info on changing a brake booster on a 1996 Sierra and also help trouble shooting a master cy. Thanxlinder a defective master has just one common symptom, a soft sinking pedal. Instructions Things ...

Question about 2001 Sonoma Extended Cab

2 Answers

how do i know if brake booster is gone ? 2001 gmc how do i know if brake booster is gone ? 2001 gmc sonoma- cleaned abs thingys and where they mount in front hubs, replaced master cyl, brakes still ...

Question about 2001 Sonoma Extended Cab

1 Answer

...a little while then repeat the same process over and over with in dash screen says service brake booster In relation to the brake booster, try looking at the vacuum hose that runs from the inlet ...

Question about 2001 Sonoma Extended Cab

3 Answers

...when i press the pedel From your discription, it sounds like your master cylinder and the brake booster are both bad. The brake booster is bad or the vacuum hose to it is leaking or unhooked the ...

how to replace brake booster on 96 gmc 1500 Remove brake master ! Two bolts holding it to the booster disconnect vac hose ! Now go in the truck follow the brake pedal up remove the pin the connects ...

Question about 1996 Jimmy

1 Answer

replace brake booster here you go...The power brake booster is a tandem vacuum suspended unit. Some models may be equipped with a single or dual function vacuum switch which activates a brake warning ...

Question about 1998 Jimmy

2 Answers

brakes How do you get the power booster out. There should be two or four mounting bolts accessed from under the dash. Usually the booster has studs and you remove the nuts. you have to remove from ...

how do I remove a power booster from a 97 GMC Jimmy Un bolt master cylinder and pull forward and to side without disconnecting any lines. Get up under dash and disconnect linkage to front of booster ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,225 Questions

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

2003 GMC Envoy
2003 GMC Envoy

1,368 Questions

2002 GMC Envoy
2002 GMC Envoy

1,418 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...