...Bolt Final Pass in Sequence 75 deg. Medium Bolt Final Pass in Sequence 65 deg Short Bolt Final Pass in Sequence 55 deg. Cylinder Head Bolt (Optional On-Vehicle Strategy) First Pass in Sequence 26 ...
...sequence, bolt No.11 will be tightened to a lower torque than the rest of the bolts. DO NOT over tighten bolt No.11. Tighten all bolts in sequence (1 through 14) to 22 ft. lbs. (30 Nm). Tighten all ...
...bolt in the sequence. Main bearing torque: Torque sequence: Step 1: torque bolts to 91 Ft/Lbs with the exception of the rear main bearing cap Step 2: torque rear main bearing cap bolts to 88 Ft/Lbs ...
...bolt sequence and tourqe for 99 jeep 4.0 motor CAUTIONDuring the final tightening sequence, bolt No.11 will be tightened to a lower torque than the rest of the bolts. DO NOT over tighten bolt No.11. ...
...bolt sequence for the cylinder head on a 1991 acura 1.8l dohc. THIS IS BOLT SEQUENCE WRITE THIS DOWN PIECE OF PAPER AT TOP PAPER BOLT SEQUENCE NUMBERS ARE 8 6 2 4 10 THEN WRITE THESE BOLT SEQUENCE ...
bolt torque sequence The Rod Bearing Cap Torque The Main Bearing Cap Torque 38 Foot pounds (Final torque)Step 1: Torque 10-12 Ft/LbsStep 2: Torque 17-21 Ft/LbsNote : Torque sequence ------------------
bolt tightening sequence for isuzu rodeo 1998 1998 Isuzu Truck Rodeo 2WD 2.2L MFI DOHC 4cyl The Head Bolt Torque Torque sequence ----------------- front ' 7 3 1 5 9 ' of ' ' engine ' 8 4 2 6 10 ' ----
BOLT TIGHTENING SEQUENCE: INTAKE SIDE 8 4 1 5 9 7 3 2 6 10 EXHAUST SIDE In sequence, torque the cylinder head bolts. Torque: 30 Nm (22 ft-lbs). In sequence, torque all bolts. Torque: 50 Nm (37 ft-lbs)
Question about 1996 SL
...the head gasket...I need my truck running again, had some problems im trying to fix. Cylinder Head Bolts (First Pass all M11 Bolts in Sequence) 30 N?·m 22 lb ft Cylinder Head Bolts (Second Pass all ...
Question about 1996 SL
Bolt - Final Pass 140 degrees Crankshaft Bearing Cap M8 Bolts 25 N·m 18 lb ft Crankshaft Bearing Cap M10 Bolts - First Pass in Sequence 20 N·m 15 lb ft Crankshaft Bearing Cap M10 Bolts - Final Pass in
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions