Questions & Answers for: Harley Davidson XLH 1000 Sportster bolt

Question about 1979 XLH 1000 Sportster

1 Answer

79 sportster left side upper motor mount bolt size left side upper motor mount bolt size On the Ironhead Sportster, the top motor mount bolt that goes through the frame is usually a 1/2 inch bolt. I'd

Ad

Question about 1979 XLH 1000 Sportster

1 Answer

I need the torque specs. on a 1992 ezgo, 4 cycle gas engine, connecting rod cap bolt I'd just use the standard torque value appropiate for the bolt size. It should be a grade 8 bolt if it's SAE size ...

Ad

Question about 1979 XLH 1000 Sportster

1 Answer

how to remove starter on 1976 sportster To remove the starter motor from you Ironhead, look at the rear of the starter motor. There are two "nuts" holding the end cap on. These are not actually nut ...

Question about 1979 XLH 1000 Sportster

1 Answer

...adjuster out and remove the spring and lock nut. The turn the adjuster inward. Remove all the bolt from the outer primary and continue to turn the clutch adjuster inwards until the outer

Question about 1979 XLH 1000 Sportster

1 Answer

I need the torque specs for the rocker boxes on a 73 iron head sporster. 14 - 19 foot pounds. Make sure you put a good sealer on the rocker box gaskets and if you use bolts, put Loctite 242 Medium ...

Question about 1979 XLH 1000 Sportster

1 Answer

...noticed that a small amount of oil is slowly leaking out of the lower front mounting hole(where the bolt normaly sits when the engine is mounted in the frame) now i would like to know if its normal, ...

Question about 1979 XLH 1000 Sportster

1 Answer

...ring and washer out, now what?? You need to turn the fork tube upside down and find the socket head bolt in the hole where the axle goes through the slider. Take the bolt out and the upper fork tube ...

Question about 1979 XLH 1000 Sportster

1 Answer

how do i remove the generator You didn't say what model bike you're working on but if your bike is equipped with a generator, disconnect the battery. Then take the wires off the terminals on ...

Question about 1979 XLH 1000 Sportster

1 Answer

...exhaust system does not have enough backpressure. You can help this by installing a 1/4" X 1 1/4" bolt in the hole at the end of each pipe for the bolt that held the baffles in. Insert the bolt

Question about 1979 XLH 1000 Sportster

0 Answer

1985 sportster 1000cc cylender torque specs what do the head bolts and rocker box bolts and cylender base bolts torque on a 1985 1000cc iron head Hi Anonymous, in a criss cross pattern and your torque

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...