Questions & Answers for: Nissan Altima bolt

removing alternator from 01 nissan altima we have been able to remove most of the bolts to remove the alternator. Can not get the third one to loosen up. Does it the bolt go to the left or to the ...

replacement of a head gasket on 2.5 liter nissan altima 2002 cylinder head bolts torque procedure for an Altima 2002 2.5liter frajogag: First off, be aware that these bolts are "torque to yield" bolts

...HOW DIFFICULT IS IT you need to remove the caliper by removing the brackets, not hard just remove 3 bolts. 1-remove the lower caliper bolt, 2- flip the caliper up and out of the upper bolt and then ...

What tools do I need to tighten the bolts on a loose muffler? gpcella: with no disrespect intended, depending on what you have determined to be the muffler under the car, will dictate the wrench sizes

...that I'am trying to take the starter off and have it looked at. I'am having a HARD time getting the bolts loose (assuming the lefty loosy policy applies) haha Was hoping to have some help of why the ...

...on 2005 nissan altima 2.5 engine would like to know how to remove the camshaft to remove the head bolts CYLINDER HEAD REMOVAL 2.5L Engines Before servicing the vehicle, refer to the Precautions ...

I need head bolt torque sequence for 2002 nissan altima 2.5L engine So 80 degrees is approx. how many ft lbs. 2.5L Engine Before servicing the vehicle, refer to the Precautions Section. Drain cooling ...

...negative battery cable. Support the transmission with a jack and remove the 4 rear mounting bracket bolts. Lightly lower the transmission to make room and pull out the dipstick tube. Remove or ...

Head bolt torque nissan altima 1995 2.4l Tighten head bolts using the following procedure: Tighten all bolts to 22 ftlbs. Tighten all bolts 59 ftlbs . Loosen all the bolts completely. Tighten all ...

how to remove front fender? The fender is attached by bolts under the hood. You will have to remove the inner fender plastic lining along with all the clips securing it.Some times the fender will be ...