Questions & Answers for: Jeep Grand Cherokee bolt

what to torque head bolts on in 04 jeep grand cherokee 4.0 6cyl. i need to know what to torque headbolts on in 04 jeep grand cherokee 4.0 6cyl. the 4th bolt back from the front on pasenger side is the

Ad

Head Bolt Torque for a 2000 Grand Cherokee Laredo 4.0L Replacing the head gasket and can't find specs for the Head Bolt Torque for my friend's 2000 2000 Grand Cherokee Laredo 4.0L the torque is a 4 ...

Ad

Question about 1994 Grand Cherokee

1 Answer

94 JEEP IDLER PULLY WON'T COME OFF,CENTER BOLT JUST SPINS.HOW CAN I GET IT OUT? using pry bar,or screw driver put pressure from in back of pulley or what ever bracket it is on and then try turning ...

What is the tension on cylinder head bolts for a jeep grand cherokee 307935 4 litre, 6 cylinder, 1999, petrol motor. Coat threads of left hand front bolt with sealant: 1st - step; - 22 ft./lbs. 2nd - ...

...and replace the alternator on a 1995 Jeep Cherokee Sport? Very simple....just loosen the mount bolt on the pivot arm and adjusting bolts....the bolts that mount the alternator....the slack will ...

I need to replace the fender and studs. Could you tell me how to replace the fender? The fender is bolted to the frame on the top, front, bottom and also at the rear, by the door. Just loosen all the

my thermostat bolt broke when i was screwing it back in. Its a jeep 2004 grand cherokee 7.7 v8 powertech. wondering what the peice is called that thrermostat housing connects to? Can you run a drill ...

Question about 1996 Grand Cherokee

2 Answers

Dear expert What are the cylinder head bolt torque settings for the 4.0L MFI straight 6 engine? Regards Dave Here are the specs and sequence: Install the cylinder head and bolts. The threads of bolt ...

Question about 2003 Grand Cherokee

1 Answer

injector bolt sheered on no. 4 cyl There's a couple of tools that make bolt extraction a little easier. The first one I would try is a reverse drill bit. A reverse drill bit looks just like a ...

Question about 2004 Grand Cherokee

2 Answers

replacing brake caliber cant get bolt loose cant brake bolt loose from caliber Use WD-40 rust inhibitor spray. Let it soak for a while,repeat a few times and it should break loose. Remember the rule ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...