Questions & Answers for: body switch

switch to body computer. If circuit is open with switch dis-connected, check output circuit from body computer. You will need a wiring diagram, if circiut is powered with switch dis-connected, replace

...and remove the body.now you con remove the two screws that holds the door switch on under the door next remove the door switch connecter from the body and install the new one.next reasemble ...

body to replace the tps the Throttle position switch,is a little black switch "mounted on the drivers side of the throttle body",There would be no reason to remove the throttle body,the TPS is held on

...switch. Instead, the automatic transaxle is equipped with a Transaxle Range Sensor (TRS), which is located on top of the valve body. This sensor performs the functions of the neutral safety and ...

switch is mounted on top of the valve body inside the transmission pan.The connecter comes through the case just above the pan rail on the left front of transmission.Check connection before you remove

...body and temp switch, it's now reporting a fault saying signal to large. Throttle body on jetta 4 2.0, I've replaced air flow meter, fuel pump, throttle body and temp switch, it's ...

weighing klo and not pounds Look for a switch on the scale on the bottom or sides and slide it to the lb. side. I think if you look on the back or where the batterys go there is a switch to change ...

...switch by looking under the body and just unscrew and replace with new switch. Reassemble in same order. By the way, the reason these switch go bad is because people get careless and let the washer ...

...all the time. suspect body computer but require pin out Year, make and model? Older ones work from the ground side of the switch. Newer ones work from the body control module, which grounds them

body to the switch is accessed through the switch. The black switch cover can be worked (scrubbed) out of its seat with your finger tips. With the switch exposed there is a small hole in the middle of