Questions & Answers for: Pontiac body mounts

...be located on the rear axle. It will mount to the axle and have a scissor arm that extends to the body. This replacement is fairly simple, remove the mounting bolts on the axle and then unclip the ...

need to install body mounts for my 1965 pontiac gto and need instrution who sells 1965 pontiac bonneville body mounts

...pontiac grand prix gtp The throttle control sensor is called a TPS which is mounted on the throttle body. You will see three wires that plug into it. The throttle body replaces the old carburetor ...

...Pontiac grand am se. 2.4 Liter and I need to know the location? MAP SENSOR LOCATION ON THE THROTTLE BODY.YOU HAVE TO REMOVE THROTTLE BODY MOUNTING SCREWS TO REMOVE.MAP SENSOR WILL HAVE A VACUUM LINE ...

...position sensor on a 2003 bonneville ssei Hi, The tps is located on the side of the throttle body. Disconnect the wiring connector and then the two mounting screws. You may need to wiggle the ...

...the cooling system for leaks. 3.6L Engine To Remove: Remove the air cleaner. Remove the throttle body. Remove the heater pipes. Remove the coolant inlet pipe. Thermostat 3.6L Remove the thermostat ...

...3.1 liter - It will be in the air snorkel in between the air filter housing and the throttle body. 3.8 liter - it will be mounted in the throttle body right before the throttle. Both will have ...

...getting swindled...lol Thanks for any help! :) Easy fix. Mounted on the front side of the throttle body is the IAC, idle air control valve. It essentially is an electronic choke. The pintle inside ...

...· 4 posts · 3 authors Stabilizer bar link nut 13 ft.lbs. Strut mount nut 55 ft.lbs. Strut mount to body 35 ft.lbs. Strut to knuckle 135 ft. lbs. 2000 Torque Specs : Specifications and General ...

...inner fender well to see it . Removal Procedure Remove the case side cover. Refer to Control Valve Body Cover Replacement . Disconnect the transaxle wiring harness. Alot of steps involved to replace ...