...control module, since, I believe, it also controls the fuel pump operation if ignition is lost. I tested the module on a module tester and it shows good. I'm wondering ,being an intermittent problem, ...
...control module) and the plug wires wat else can i do to get this beastie up and running please help!!! thanks mychael the primary ignition system is ignition pick up coil and module.thy are both in ...
...control module in my 1985 fiero gt i think i need to change my ignition control module on my 1985 fiero gt but cant find it Take off the distributor cap, it is held on by two screws and has three ...
...control module,crank position sensor,coils. 1988 4 cy You have done everything but what was needed. Whenever the engine backfire, it is always the timing problem It is out and must be set right. ...
...Control Module) could be faulty, and the ECM's that were manufactured back then were prone to faults, and that is also why they can be purchased for only around $70.00 at most auto part stores. The ...
1987 fiero cranks but wont start If the tach doesn't move while cranking, it's likely the ignition control module in the distributor.
won`t stay idled my fiero won`t stay idled. what can i do to fix the problem. Can you describe the problem ? Have you checked the idle air control valve ? Is the throttle body clean ?
idle. What could cause this problem. Cold start fuel injector may not be working. Check throttle body for carbon buildup and the Idle Air Control may be stuck or restricted. Is this the 2.8 V6 engine
...control module. When cranking does the tach register a couple hundred rpm? If the tach doesn't register the ICM is the likely culprit. It's in the distributor. You unscrew two little screws (don't ...
...body control module with a 2.8 engine Fieros do not have a 'Body Control Module'. They have an ECM for the engine, V6s with cruise control have a module behind the carpet by gas pedal, 87-88s have a ...
Usually answered in minutes!
159 Questions
91 Questions
85 Questions
62 Questions