Questions & Answers for: kawasaki ZX-6R Ninja blue rubber band

AT 6000 TO 7000 RPM BIKE DONT PULL IF I RIDE MY BIKE, AT 6000 TO 7000 RPM THE BIKE DONT WANT TO PULL. IF IT STANDS STILL IT REFS UP Hi and welcome to FixYa, Offhand, I would suspect an airleak on the ...

1996 zx6r I know this sounds ridiculouse but i can`t figure out how to take out my light bulb in the front and also i am looking for the rear fairings for my bike thanks Actually u can reach in and ...

ijust took my bike for an mot it failed on the rear break stiking, the mans advice was to take th caliper off, appy some copper grease and replace, but there seems to be a rubber seal that has been ...

The best way to remove a carb from a 1994 ninja ZX-6 and the tools required. Ok you will have to remove the seat and the fuel tank. You will need metric wrenchs and sockets and a stanard screw driver ...

when i rev my bike in nuetral its bogs out around 11 grand and then revs higher is that the power band or something else A couple of things here, the frst is you should never rev your bike standing ...

how do i remove the coil to change my spark plugs out of my kawasaki ninja zx6r Those are stick coils, just unplug the connector at the top pf the coil and then they just pull out, there is rubber ...

I'm looking for a paint code for my 2001 zx6r candy blue Touch up paint requierd Its Candy Lightning Blue... there is no color code... you Top coat is 3710 base coat is 1999 ColorRite

after about 100 miles or so my header tank slowly fills with water,i can **** it out of the header tank back to the max then put it back in the rad, so the rad is full and the header tank is at ...

clogged carbs need to remove and clean or rebuild Now here's a common problem. Carburetor service requires patience and attention to detail, especially on motor cycles. Handle the parts carefully.