top end bog on 2003 cr250r only happens when the bike is wide open and doesnt happen all the time but always happens after landing jumps or going through woops what happens when you do either of them.
... disconnect the black / white wire from the engine stop button to the CDI; pulsating low ACV on the blue / yellow & white / green wires from the pulser coil; pulsating high ACV on the blue & ...
How do I take the brake drum off of a 2001 Honda Recon? Loosen the rear-axle nut Rotate the chain-tensioners [on each side of the rear-axle bolt] to their minimum points. Remove the wing-nut of the ...
...the filter completely. Don't ride it like that, of course. Also, make sure the spark is white/blue not orange. And that the plug isn't too wet as that could mean a flooding
when i kick my bike up it just starts reving up on its own to the top end This is caused by an air leak between the carb and the cylinder. The un-carburetored air leans the fuel mix. Replace any ...
...rubber intake manifolds. The petcock has a vacuum line as well as part of the emission system. 1. Check the intake manifold for cracks. 2. Ensure the bands used to tighten the manifolds down on the ...
Just picked up an 89 Honda CR 250R. On low end the machine runs normal, however just when the power band should come on it falls on it's face. Engine gurgles, like it's flooding out. I Tried a
how do you remove the front wheel Position bike upright so it won't tilt on lean forward with front wheel off the ground. Remove front brake caliber & secure so it dont hang by the hose.Remove
...methods of colored "SMOKE SIGNALS" here is a breakdown of their meaning: 1. COLORLESS OR SLIGHTLY BLUE SMOKE on start-up means your air/fuel mixture is at the right composition and everything is ...
rubber intake manifolds. The petcock has a vacuum line as well as part of the emission system. 1. Check the intake manifold/s for cracks. 2. Ensure the bands used to tighten the manifolds down on the
Usually answered in minutes!
