Pitco Fryer Problem is pilot outage. Already have replaced high limit switch, Thermopile, and pilot assembly. Pilot seems to be going out when t-stat is satisfied and burners are shutting off, seems ...
SG-14 backfires when turning on I have 2 SG-14s and the wire screen at the end of the burners where they hook up to the tank tubes seem to get clogged or burnt looking, causing the fryer to backfire ...
I have a Pitco 35C+S fryer that goes out. When I relight the pilot, turn the gas on. the burners light and blow flame hard for a second or two and then die down to normal. It will relight with the ...
...unit , the pilot light may be too small and not lighting up the main gas as it should and when it does it is too late too much gas in the chamber and blows out through the front door. Hope this
...its time to reignite, it gives off a ploom of flames and blows out the pilot and cuts off, whats worng, its been cleaned thuroghly. Gas pressure may be low that's why burner ignition is
my fryer is not blowing the flame out in the inserts tube it is turning toward the top There may be an excessive carbon deposits or soot formation inside the heat tubes of your fryer that's why ...
...blows out when it calls for gas Pilot lights when you turn the thermostat on it takes a couple of seconds for it to catch but when it does it lights so violently that it blows out the pilot light Hi ...
Question about 35CD Deep Fryer
BLOWS OUT PILOT LIGHT CAN WORK FOR 3 OR 4 TIMES SHUTS DOWN NICELY THEN WOOF SMALL BLOW BACK CAUSEING PILOT TO BLOW OUT THEN HAVE TO WAIT 10MINS TO RELIGHT ALL BURNERS ARE CLEAN AND NEW THERMO COUPLING
Question about 35CD Deep Fryer
Will the exhaust stack diameter cause rapid airflow to blow out the pilot? I had to have a custom exhaust stack built to fit under an exhaust hood. It tappers from 14x4(bottom) to 12x3.75(top). Pitco ...
Usually answered in minutes!
180 Questions
82 Questions
55 Questions
17 Questions
6 Questions