Won't go past 68... I have a dayton gas furnace that when you set the heater temp past 69 it will heat it's self up to 68 and then just start blowing air. It won't pause or anything it just keeps ...
Question about Gas Furnace Heater
pilot wont stay lit installed new gas valve and new thermocouple i could not get to stay lit Is this a standing pilot furnace, or electronic igniton? If standing pilot, does the heater use a fan to ...
flames burn then die down hello, I have a dayton lp gas heater. bought it second hand. intalled it and had gas hooked up. problem is, it will come on and fan will work, however, the flames underneath ...
...to start however it will not ignight..The fan starts up like normal but it only blows cold air??? I would need a lot more info. if this is a natural gas furnace you may have a bad hot surface ...
...gas and then it goes out and blows hot air out the pilot or gas wont stay lite we need to know what the thermocouple looks like for this model Hi the thermocouple is a long copper wire that goes back ...
gas heater with the newer style electronic ignition assembly. My problem is that it often won't light on it's own. It's weird, but what I've found is that if I remove the cover and either wait for the
...to start it and the burners start up, but as soon as the fan kicks in the burners stop and only blows cold air all the time. I have read the owner's manual and it says if the furnace is installed ...
...gas valve was not opening, valve is controlled by a vacuum switch, vacuum is created as fan blows air down tube past bent up metal flap near front bottom of heater (slight low pressure zone created). ...
Question about Gas Furnace Heater
dayton gas furnace model 3e385 works and lights but as soon as fan comes on the unit shuts off and lights again wondering what was wrong Check heat exchanger for cracks or holes which will cause the ...
Question about Gas Furnace Heater
i have a Dayton hanging gas (propane) heater 3E838 series 1067A model z21116 when the heater ignites its like to much gas and blow out the side vents ???? sounds like the air to gas setting is wrong, ...
Usually answered in minutes!
273 Questions
93 Questions
42 Questions
37 Questions
46 Questions