Questions & Answers for: Oldsmobile Cutlass Supreme bleed coolant

...bleed" the air from the system after replacing the thermostat housing? On some GM vehicles, there is a brass "bolt" threaded into the housing. Some models will develop an air-lock, which prevents the ...

Ad

coolant, put the bleed screw back in. Be sure and clean up any spilled coolant so your pets can't drink it. 4. Check for bad water pump and/or deteriorated belt. 5. Check for bad head gasket, possibly

Ad

Question about 1988 Cutlass Supreme

1 Answer

...the air, also might be one by the water pump. Its a common problem on them cars after you have drained the coolant to do thermostat or waterpump. Just bleed off the air and you should be good to

Question about 1996 Cutlass Supreme Coupe

1 Answer

than cold on its own. Engine is at temp. check your coolant level, if it is to low air gets in the system, may need to bleed air out if it has run low, there is a brass bleeder screw by the thermostat

...you have the radiator or engine cooling hose replaced recently? if yes, maybe the system has to be bleeded) - bad engine thermostat (does you temp gauge in your dash indicate that engine operates at ...

Question about 1996 Cutlass Supreme Coupe

1 Answer

...bleed the cooling system everytime you add coolant when doing work on a car's engine. They have a bleeding screw near the thermostat housing or on the housing itself. After getting the engine to ...

Question about 1997 Cutlass Supreme

1 Answer

...relays.what else could it be.also did radiator cap. coolant temp sensor for the computer, did you bleed the air out of the system as well that is a big thing on those to be sure theyre bled out

...coolant recovery bottle as necessary. Remove pump assembly. Transfer pulley as necessary. Reverse procedure to install, them bleed power steering system as follows: Turn wheels all the way to left. ...

Question about 1996 Cutlass Supreme Coupe

1 Answer

housing off,and remove,also the screw is to bleed air out of the system once you open it,just leave the screw open once you fill it with coolant and close a couple of times until no air. TIM..........

Question about 1996 Cutlass Supreme Coupe

1 Answer

...bleed the coolant system on a 1992 cutlass supreme Normally, you shouldn't have to bleed the cooling system but, there are two bleed valves. One is just above the water pump, and the other is on ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...