Questions & Answers for: Jeep bleed coolant

Question about 1999 Grand Cherokee

1 Answer

...coolant bleed port. Top hose gets hot indicating flow. However, she still overheats. Is there a way to test water pump output pressure to ensure that the flow I'm sensing is sufficient? I have heard ...

Ad

...bleed screw" slightly open and note as the air bubbles escapes from the screw. Also make sure the radiator is topped up with sufficient coolant. Funny enough, the mechanic should have taken care of ...

Ad

Question about 2002 Grand Cherokee

1 Answer

coolant is low. bleeding system? cMy coolant indicator says low. I filled it with 50/50 mix. I noticed a bleeding unit on the mail coolant hose. What is it for?oolant is low. bleeding system? Hi.You ...

...BLEED COOLANT SYSTEM.ALL YOU HAVE TO DO IS FILL RADIATOR WITH COOLANT UNTIL ITS JUST BELOW THE CAP.CRANK CAR UP LET ENGINE IDLE UNTIL IT WARM UP UNTIL THERMOSTAT OPEN UP.ADD COOLANT UNTIL COOLANT ...

are not turning on! Ive chande the upper radiator hose and added water and coolant mixed is there a bleeding system on this ? no bleeding necessary,i would recommend let it run for awhile to allow the

Question about 1998 Cherokee

2 Answers

...will draw the coolant out and the system will bleed the air out. I GOT THE SAME PROBLEM WITH TEMP GAUGE, BUT JUST SUGGESTION FROM A FIEND CHECK TO MAKE SURE YOUR HOSES ARE NOT COLLAPSING AT HIGH

Question about 1993 Grand Cherokee

1 Answer

...bleed valve before any coolant is added. If you do not do this, air can remain trapped inside the system and you won't get all the air out. On 1998 and later models with 2.7L engine, the valve is ...

Question about 1993 Grand Cherokee

1 Answer

...bleed valve, and you still think air might be trapped in the engine, you could find a coolant temperature sensor or sender unit that is at or near the top of the coolant passages or areas of the ...

...bleed air from coolant system Take radiator cap off before you start the vehicle when its cooled off of course then leave cap off watch temp gauge till it reaches normal running temp the fluid should ...

...coolant begins coming out of the cooling system bleed hole. Install the cooling system bleed plug. Fill radiator to top and install radiator cap. Add sufficient coolant to the reserve/ overflow tank ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...