Questions & Answers for: Oldsmobile Silhouette bleed

...still acts like waterpump isn't pumping....or there is a clog somewhere....i have tried to bleed the lines while the van was running....the bleeder off the pump bled fine....but the bleeder ...

...Chaeck to make sure that the coolant system is free of air. To do this on this model, you must bleed the air through the bleed valves. One is located on the thermostat housing on the right near ...

...the old gasket off install the new water pump and gasket reassemble the vehicle loosen the AIR BLEED SCREW ON THE BYPASS PIPE ABOVE THE WATER PUMP refill the cooling system with coolant prev ...

...and the O RING SEALS lube with a silicone grease 9 after the vehicle is all assembled LOOSEN AIR BLEED SCREW ON THE BYPASS PIPE 10 refill cooling system till coolant FLOWS OUT THE AIR BLEED IN A ...

whats the proper way to bleed the breaks Bleeding the Brake System (ABS) Auto Bleed Procedure NOTE: Perform a manual bleeding procedure. If the brake pedal height and firmness results are not achieved

my breaks are going all the way down and the breaks are new it has fluid and they have been bleed. Bleed again,not done correctly

...still spongie abs light still comes on once in awhile.. If the brakes are spongy you will have to bleed the brakes again. It sounds like there is still air in them. If you are doing it manualy make ...

cap and the overflow completely filled up to the top. there can be air pocket somewhere you need to bleed system properly. rais the front let is idle bleed it thru bleeding screw. be sure that bubbles

...and let it warm up until the thermosat opens. Standing in front of the vehicle there is a small bleed valve located on the right just above the thermostat open it until the coolant comes out and ...

2002 silhoutte new tstat,radiator,belts and hoses runs hot no water at bleeder valve water pump 2 yrs old It is running hot because have an air lock in the system. Check that the bleeder valve is not ...