Questions & Answers for: Harley Davidson FXR Super Glide bike frames measured

the wheels as that measurement was off about a quarter inch short on the left side. Didnt help. The bike had been wrecked when i got it. Replaced down tubes, front tire and wheel, carb, tank and right

...Check across the battery with the engine running at high idle with a FULLY CHARGED battery in the bike. You should read 14.5 - 15.0 volts DC. If not, pull the plug where the voltage regulator plugs ...

...about the rubber front engine mount, yes, it is easily replaced. You'll need a way to hold the bike up straight. Take the bolts out of the front engine mount and useing a small scissors jack and ...

is 93 harley positive ground No most( if not all) bikes are -neg to ground or frame

I notice that when I start my bike there is a churp sound coming from the engine. The clutch is also very stiff. Any ideas? Although you didn't say what model Harley you own, I would bet that it's one

2003 flhtci parasitic drain? new to me trike. 2,000 miles. bought last fall, rode twice. started it the end of april just fine. tried to start last week and the battery was stone cold dead. would not ...

...up. need info on clutch adjustment. Loosen the cable adjustment that's on the right side of the bike just behind the starter solenoid. Turn the adjuster in a good bit. Remove the derby cover and ...

I just purchased a1980 FXWG The vin # is 9g50938j0. What I would like to know is of the bikes produced in 1980 how many were FXWG and what were the color options.Is there anyway nto find out what ...

...You need to know the proper 10 lb pressure belt deflection for the particular year and model of bike. Once you know what the deflection should be if the belt is too tight loosen the axle cone nut ...

...frame I want to put a 1990 FXR evolution motor in a 1972 FLH frame Unless there are some custom bikers reading this I think you need to go online to a reputable custom shop for Harley's and call ...