...door on my 1999 suburban is now not opening from the inside, what happened? How much is this going to cost to fix? Can I do it myself? VERY common issue.. the handle being replaced is ok.. but the ...
...door is bent, then it's going to cost extra for the replacement of the door also with the hinge. Without knowing if the door is also bent where the hinge is welded to, a cost price is hard to give so ...
...the front door, how can i stop it buy a new door gasket from a dealer and install it or pay someone to install it for you. unless of course the door is bent then you will just have to live with
...door latch lever bent or corrodded, the outer and inner handles use the same door latch but not the same mechanisms or rods to operate the latch. Once you remove the door panel and the inner dust ...
...door handle to the latch may have come disconnected,bent or the clips that hold it attached to the handle and latch may have broken or come unfastened.you will have to remove the inner door panel to ...
bent door hinges on driver and passenger side doors of truck. wind took the doors and over extended them into the front fenders...hinges ruined. they are mig welded, has any one replaced these. do you
...is probably bent at the door hinges. You need to adjust the latch bar on the door jam. There will be two bolts to loose and you can move the bar in all directions. You probably need to move it
...but can happen, check the wires from the door too the cab..after all the drivers door is the one most useds and the wires being bent back and forth over time can break in this area causeing
Question about 2003 Yukon XL
...door bent back too far now won't close. Can I fix it myself, or how much will it cost you will have to take to a shop they will have to remove the door and strighten the post that the hinges are on ...
Question about 2003 Yukon XL
and are not loose..but the door will not close tightly ? One of the brushes might have caught it and bent it a little. You might need to do some strategic bending of your own to get it back into place
Usually answered in minutes!
2,225 Questions
1,363 Questions
1,368 Questions
1,418 Questions
1,123 Questions