Questions & Answers for: bent door

Ad

Question about 1997 328

1 Answer

...mine a little to get it to stay closed. Unfortunatly I left it open the other day when I went thru a car was after fueling and the door is bent now so I have another issue to deal with. hope that ...

Ad

door lock. If the leaver was bent, the travel distance is shortened and does not push the leaver on the door luck to release it from the striker. Your going to have to remove the door panel and get to

Ad

door will not unlock believe arm is bent or un latched door will not unlock believe arm is bent or diconnected unable to remove panel or open door try using a slimjim to unlock door.

Question about 1997 DeVille

2 Answers

correctly. I have seen a door bent and wouldn't close properly just had to bend it back.I don' know how it gets bent unless it's like tlentzsr said someone siting on it.Kinda unusal though

Question about FTF2140FS Front Load Washer / Dryer

1 Answer

...door is bent a bit and now won't shut right unless slammed just right. I doesn't look bent but must be. I know I have trouble opening it after a wash where it seems stuck and I am sure the previous ...

Question about ATB1832AR Top Freezer Refrigerator

2 Answers

...got bent when the door was opened too far, or most likely one of my kids pushed it open wide. I took a pair of pliers and bent the tab back towards its normal position. It shuts very solidly

...door handle bent inward. rear body dented and scraped as well. Can this be fixed or do I need both doors replaced? No way to tell without looking at it and taking measurements.It may be cheaper to ...

Question about Profile Spacemaker Over-the-Range Microwave

1 Answer

...bent to sense door closure. Take apart the microwave and re-bent this switch tab...it's relatively easy to find and correct. The door switch might be bad too...won't cost much. 9 times out of 10 it's ...

Question about Profile Spacemaker Over-the-Range Microwave

1 Answer

...And, the door could be bent from leaning on it, resting clothes on it(if it opens/closes vertically). Also, if it is bent enough, the strike/catch might be mis-aligned and not holding

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85108 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

21790 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...