Questions & Answers for: GMC Jimmy ben 10

1997 Jimmy starts very hard when engine is cold My 1997 Jimmy has to try to start 3-10 times when the engine is cold, it fires once or twice but won't start. after doing this 3-10 times, (the number ...

Ad

Question about 1993 Jimmy

1 Answer

...idle(rich) stalls in gear 1993 vortec v6 in gmc jimmy. rough idle stalls when stpo in drive or rev. ben sitting 6months. took off air box seams to run a little better Basically clean up before use ...

Ad

...concern? Ben Probably not. You can run 'high mileage oil' which helps some and running 10/40 oil instead of 10/30 will help also. Replacing the oil pump and cleaning the intake screen might help

Truck starts, runs for 5-10 seconds, then dies Truck starts, runs for 5-10 seconds, then gets rough idle and dies. Outside temp has been around 0 during day and -20 at night. Tank has 1/3 gas. Is my ...

keep blowing the ecmb fuse in my 1991 s-10 keep blowing the ecmb fuse in my 1991 chevy s-10, which shuts off the fuel pump check your grounds & the fuel pump connections.the ground should run to ...

trying to find diagrams on different 7.5 10 hole differential for 93 gmc jimmy and why they are different The baisc differences are ratio , locking or open carrier and drum or disc brake.There are two

Question about 1993 Jimmy

1 Answer

what would be wrong with my Jimmy it was running perfectly fine and driving along and shut off and would not start again. They checked the fuel system, including injectors, and electrical. Can't ...

won start up after driving it to store unless i wait 10 minutes. My 99 jimmy 4.3L will start up I go to the store and is wont start after letting it sit for about 10 minutes it will start. I changed ...

Question about 1996 Jimmy

1 Answer

timing mark on pully trying to find timing marks on engine took distributor out to replace intake gasket the timing marks are on the timing cover housing at the top of the crankshaft or just slightly ...

Question about 1999 Jimmy

1 Answer

what could be problem after riding on 5 cylenders i finally got a chance to replace bad valve lifters after i was done it ran perfect for about 10 min then ran bad and died i know the distributor and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

1998 GMC Jimmy
1998 GMC Jimmy

1,127 Questions

1999 GMC Jimmy
1999 GMC Jimmy

1,104 Questions

2001 GMC Jimmy
2001 GMC Jimmy

838 Questions

Manuals & User Guides

Loading...