Questions & Answers for: belt tensioner houseing

Question about 2004 Touareg

1 Answer

TIMING BELT POINTS. I HAVE A 2004 TOUAREG V8, I CHANGED THE THERMOSTAT AND NOW I CAN DO THE POINTS, HOW CAN I AQUIRE A DIAGRAM ALSO THE CAR WAS OVERHEATING IT DID NOT SEEM THAT THE THERMOSTAT WAS IN ...

Ad

Question about 1994 Caravan

2 Answers

...belt tensioner that is moveable and holds tension on the belt. Turn the belt tensioning pulley in one direction to allow you to fit the belt over it after the belt is in all the other pulleys. Then ...

Ad

Question about 2004 Forenza

1 Answer

...belt over the tensioner. Remove the wrench from the tensioner bolt and the belt will tighten itself. Install the air filter housing assembly into the vehicle. Install the air intake tube and the air ...

...belt tensioner? There should be a small hole in the upper part of the timing belt tensioner housing and also on the end of the timing belt tensioner plunger, and the plunger must be compressed back ...

Question about 2001 Durango

1 Answer

...Belt over idler pulley, let tensioner rotate back into place and remove wrench Coolant Negative battery cable Start and warm the engine and check for leaks. 4.7L EngineTo Remove: Before servicing the ...

tensioner pulley against belt. 5. Ensure belt is taut between injection pump sprocket and tensioner pulley as well as crankshaft sprocket and camshaft sprocket. 6. Position tensioner lever [8] against

Question about 1996 Trooper

2 Answers

...the timing belt tensioner into the housing and tighten to 21 ft. lbs. (28 Nm). 3. When the tensioner is in place pull the retainer pin to allow tensioner to extend to the pulley bracket. Good

...belt and tensioner. Upper and center timing belt covers. 3. Position the engine so that the No. 1 cylinder is at TDC. WARNING Cover the timing belt to protect it from being contaminated with coolant. ...

Question about 1994 Impala

1 Answer

...belt tensioner I would like to know how to remove the tension so I can change the belt and removing the tensioner itself Once the belt is off there will not be tension and will be safe to remove the ...

belt housing if there is white smoke coming from timing belt housing then it sounds like the tensioner is locking up and causing the belt to smoke replace tensioner and belt.!!! We Are Here To Help !!

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...