...Belt and Holds Tension on it. You will need to get a Wratchet, Socket, and Cheater Bar. Turn the Bolt On the Top Large Pulley with the Wratchet and Cheater Bar. This will Lower the Smaller Pulley So ...
...tension as necessary. its more likely to be a belt that is slipping but also could be a idler pulley or belt tensioner pulley,get a bar of saop find a place where you can touch the belt without ...
...area by my belts. could this be the timing belt or just a worn belt or a tensioner? check the tension of your timing belt. it should have some but not much wiggle room. be sure its not over ...
...belt tension by turning the belt tensioner counterclockwise, remove the V-ribbed belt from the belt tensioner. INSPECT V-RIBBED BELT TENSIONER ASSEMBLY Check that nothing gets caught in the tensioner ...
Installing new Serpentine belt To make a tough task much easier, go to any decent auto parts store and ask to rent a serpentine belt wrench... they come with multiple sockets and crow foot wrenches ...
...tension on belt should release ,or you can do it by the tensioner it looks like small wheel that the belt also goes around it ,put a socket or open wrench and pull towards the front it gonna take ...
tension on the belt and slip the belt off the component pulley.Re-locate the component to regain tension on the belt and tighten the pivot and adjustment bolts. you can find the best replacement parts
Question about 2004 Tacoma
...acceleration only, what is causing this noise???. V6 Engine....automatic transmission, Serpentine belt and a.c. belts intact... Could be your belt is stretched and needs to be replaced,can't
Serpentine belt rubbing I put a new serpentine belt on my 4.0 liter 2006 Tacoma. After driving it over the weekend I noticed that the smoooth side of the belt now has grooves worn in it. These grooves
Question about 2006 Tacoma
I need the proceder to change the belt how to slack off the tensioner How to loosen tention there is a special tool used to move the auto tensioner. you could try to use a 3/8" ratchet if it fits the ...
Usually answered in minutes!
352 Questions
307 Questions
394 Questions
295 Questions
304 Questions