Questions & Answers for: Mercury Sable belt tension

...tension in the belt. How do I loosen tension from the tensioner to complete the installation of the belt? there should either be a whole for a ratchet or there is a nut on the tension pulley that you ...

...tension for the belt. With doing this it had no effect on the the tensioner. My question is there is a bolt that is in the center of the tensioner that mounts it to the engine. I need to know what ...

...tension on the belt get a 3/8 socket and make sure you get the right socket and use this to pulll the tensioner down and the diagram for the belt is normally under the hood somewhere and if it isn't ...

...belt tension what tool to use you can use a jack handle, or a large screwdriver....just pry on the tension pulley enough to release the tension on the belt.... A special serpentine belt tool. If you ...

...belt you ned to measure the tension before loosening pully because that is going to be your stepping stone for new installation if the tensions are not exact it can throw off the tension causeing ...

...belt tensioner pulley on my 96 sable dont know exactly what to do and am afraid tension spring will somehow kill me cause i have no experience in working on cars no remove the belt remembering the ...

...belt which is tightened automatically with an tension wheel. If this is the case you have the wrong size belt and need to obtain the correct, smaller belt. The Sable/Taurus vehicles use an automatic, ...

I need to replace the serpentine belt on my car. How do I do that? These instructions will help you . and also the picture below will help you more. 1 Locate the belt-routing diagram, printed on the ...

...belt tension and slide the belt off the pulleys. On 3.0L (DOHC) engines, rotate the tensioner counterclockwise to relieve belt tension and slide the belt off the pulleys. To install:Install the drive ...

adjusting belt tensioner How do I adjust the tension on the serpentine belt? that is the belt tensioners job it does it automatically